by Alexey Smirnov | Oct 17, 2016 | Testimonials
Introduction The engine was put together without replacing or machining any parts. According to our most conservative estimate, over 30,000 hours that the generator was in operation, the user saved at least $150,000 on repairs, fuel and oil consumption. And spent only...
by Alexey Smirnov | Oct 17, 2016 | Testimonials
Introducion “As you know, we have been incurring serious maintenance problems with our fleet of 200 transit-cab vehicles. On average, we have had 13 cabs per day in for an engine overhaul or replacement. The down time, parts, and labor costs have been excessive....
by Alexey Smirnov | Oct 17, 2016 | Testimonials
a. Swiss Precision Parts. Operation – Special Grooving O.D.; Material – 52100 Die Tool Steel; Coolant – Oil Requirements – Must hold tolerance of 0.0002 in on diameter and 64 microns in on finish. Customer usually maintained these parameters...
by Alexey Smirnov | Oct 17, 2016 | Testimonials
“My responsibility here at Alcoa Fujikura is primarily to make sure all our equipment is operating efficiently. Our main client is Ford Motor Company, and we cannot afford costly down time. Toyojuko makes a machine called Orimper 6 WB that we use in our plants. Our...
by Alexey Smirnov | Oct 17, 2016 | Testimonials
Without POLYTRON MTC The oil temperature of PAC 250 screw compressor was running 192° F and its air up to 240° and than shutting off. We had the air and the oil coolers of the compressor serviced, but it continued to automatically shut off approximately every one and...
by Alexey Smirnov | Oct 17, 2016 | Testimonials
Without POLYTRON MTC $28,416.00 per year With POLYTRON MTC There has been no maintenance performed other than filling the oilers. Taking into consideration the cost of Polytron MTC that was used per year, the savings for the year was $25,300. The decision was made to...
